VX-824--Prog for 2 tone decode

Forum dedicated to discussion on Vertex Commercial Radio products
Post Reply
redbird
Posts: 136
Joined: Mon Mar 11, 2002 9:34 am

VX-824--Prog for 2 tone decode

Post by redbird » Wed Oct 29, 2008 5:29 pm

I have programmed a VX-824 for 2 tone decode and tried every variable and it will not open for a voice message. I get decode and a beep and the display "Group Call", but no voice. I am not using PL tone on the paging signal and I have set the channel for no PL decode. I have the latest software. Version 3.10. Is it possible to get a voice message after the tones?

radio259
Posts: 137
Joined: Sun Aug 01, 2004 7:11 pm
Location: Pittsburgh Pa

Re: VX-824--Prog for 2 tone decode

Post by radio259 » Wed Oct 29, 2008 6:53 pm

i do not have my alptop here, but in the paramater section if I remeber, you need to tell it to unmute when 2 tone received. I think it is in the pull down where you set which 2 tone pair, or pairs to open to.

if this was no help, let me know. I can send you my file tomorrow from work, just look it over. i use one for paging for my fire company. You can also change the little blinky light to different colours ect.

Paul B
WQDE 855
KB3RUL

radio259
Posts: 137
Joined: Sun Aug 01, 2004 7:11 pm
Location: Pittsburgh Pa

Re: VX-824--Prog for 2 tone decode

Post by radio259 » Tue Nov 11, 2008 9:35 am

Redbird, How did it go?? Were you successful?? if not let me know. Will try to wlak trhu it with you somehow.

Paul B
KB3RUL
WQDE855

redbird
Posts: 136
Joined: Mon Mar 11, 2002 9:34 am

Re: VX-824--Prog for 2 tone decode

Post by redbird » Tue Nov 11, 2008 10:27 am

Hello Paul. Thanks for the help. I have not been able to get the radio back to complete the programming. I am sure that I can compare your program with mine and find the problem.

Post Reply

Who is online

Users browsing this forum: Google [Bot] and 1 guest