Is there a way using PC Configure to "clone" a set of channels/zones from a 5300 to a 5100 series radio? I entered a set of radio parameters for a 5300 (UHF) radio, and I wanted to program these same channel/zone parameters into a 5100 series (UHF) radio. Is there any way to transfer data between data sets?
Thanks very much!
Steve
5300 to 5100 cloning possible?
Moderator: willbartlett
- Intrinsically Safe
- Posts: 347
- Joined: Sat Oct 13, 2007 9:19 pm
Re: 5300 to 5100 cloning possible?
Steve,
Using PCConfigure, just do a radio>Series>5100 and it will change everything for you. You will need to adjust a few settings but the freq's will all still be the same.
I.S.
Using PCConfigure, just do a radio>Series>5100 and it will change everything for you. You will need to adjust a few settings but the freq's will all still be the same.
I.S.
Sean Penn: Last year I went to Iraq. Before Team America showed up, it was a happy place. They had flowery meadows and rainbow skies, and rivers made of chocolate, where the children danced and laughed and played with gumdrop smiles.
Re: 5300 to 5100 cloning possible?
Fantastic!
Thanks so much for your expertise!
Steve
Thanks so much for your expertise!
Steve
Intrinsically Safe wrote:Steve,
Using PCConfigure, just do a radio>Series>5100 and it will change everything for you. You will need to adjust a few settings but the freq's will all still be the same.
I.S.