Page 1 of 1

EFJ Avenger questions

Posted: Wed May 18, 2016 1:06 pm
by DLW
Hi... My first post here so I hope I'm not asking a prohibited question about programming software. I have two old "Avenger GX" radios, one UHF (242-7403-121) and one VHF (242-7401-122) that I've been using for several years for the VHF/UHF ham bands. I've been needing to update the repeater freqs. I have programmed into them but I've misplaced, lost, or maybe even accidently tossed the software disk I had since it was on a 3.5" floppy.
I'm looking at possibility buying "PC Configure" software which sounds like it will work with most EFJ radios but I'm unable to tell if it works with these older Avengers or not?
Can anyone tell me if that will work w/these old radios or know of other available software that can be purchased that will work?

Thanks much... DLW

Re: EFJ Avenger questions

Posted: Tue May 24, 2016 9:44 am
by Intrinsically Safe
PCConfigure will NOT work with the Avenger Radios.
EFJ doesn't support those radios anymore either.
My only advice would be to try and contact Paul from Paul's Two Way.
http://www.paulsradiorepair.com/

Re: EFJ Avenger questions

Posted: Fri Jun 17, 2016 11:35 am
by DLW
Thanks for the response. I actually found mine again so all is good...