Problem programming SOME M-PD's and M-PA's?

Forum dedicated to the Harris PSPC Product group items such as Orion, M7100/M7200/M7300, P7100/P7200/P7300, Harris Unity XG-100, GE Orion, GE Master Repeaters, EDACS Trunking, Pro Voice, PC Configure, RPM, and other topics relating to Harris, MA-Comm, Ericsson, GE products.
Post Reply
Elroy Jetson
Posts: 3
Joined: Thu May 09, 2002 2:53 pm

Problem programming SOME M-PD's and M-PA's?

Post by Elroy Jetson » Thu May 09, 2002 3:00 pm

I've encountered a small number of M-PD's and M-PA's (and an M-TL or two) that work normally but when I connect my programming cable to the radio and turn the radio on, the radio won't power up. Nor will it do so until I remove the cable and recycle the radio power.

Yet, other M-PD's and M-PA's work and program normally with this exact same programming setup.

I'm using the Price Industries radio interface box.

Two different computers, same results. Even with different software on each computer.

Any ideas?

Elroy

User avatar
vcaruso
Posts: 110
Joined: Mon Jan 21, 2002 8:00 pm
Location: Passaic County, NJ

Post by vcaruso » Fri May 10, 2002 12:08 am

Elroy,

I purchased a few M-PD s from the state of New York and ran in to the same problem on a few, I took it to the local GE shop and they programmed them without a hitch.

I remember reading some where that certain vintages of these radios required power from the programming cable. I have dig through the manuals that I have in pdf format and see if I can find the tech notes.

As soon a s I find it I will post it on my site so you can view it.

Vince

Post Reply

Who is online

Users browsing this forum: Baidu [Spider] and 2 guests