I have a enhanced charger for a Mrk-2 radio the problem is im getting no power at all when the radio is place into it wiring is correct blk to neg yellow to pos check at connector have power
any ideas what to look for ?
Enhanced Vehicle Charger
Re: Enhanced Vehicle Charger
Check to see if the charger is set to ignition sense. There are two ways to try it. The first being to hook up the ignition sense lead which connects to pin 10 on the DB25 at the rear of the charger to +12 volts and see if it comes on.
Or, remove the three phillips screws on the bottom of the charger and pry off the front cover. Locate DIP switch SW3 and make sure position 1 is ON and position 2 is OFF.
Or, remove the three phillips screws on the bottom of the charger and pry off the front cover. Locate DIP switch SW3 and make sure position 1 is ON and position 2 is OFF.
Re: Enhanced Vehicle Charger
Go to the Repeater Builder's site at http://www.repeater-builder.com/ge/lbi-master-list.html and look up LBI38935 which is the install/operator's guide for the enhanced vehicle charger.