Icom F1821 programming

Forum dedicated to discussion on Icom Commercial Radio products such as F70, F80, F1721, F2821, F9011, F9021, F9411, F9521, F9511HT.
Post Reply
KK5FM
Posts: 4
Joined: Thu Sep 07, 2006 9:57 pm
Location: Guthrie, OK

Icom F1821 programming

Post by KK5FM » Sun Oct 15, 2006 4:53 pm

I have an Icom F1821d that I am trying to program. When the Icom transmits in P25, the receiving radio (A motorola) gets the unit ID just fine. When the Icom is receiving P25, (from a motorola radio) it only shows a "1" (The Motorola has a unit ID other than "1") The obvious things in programming have been set, such as "Unit ID display on receive."
Any idears?

jsikora
Posts: 99
Joined: Thu May 12, 2005 12:51 pm

P25

Post by jsikora » Wed Dec 27, 2006 10:01 am

We had some issues similar, but thought they were all resolved in the last firmware. Another list is the caller list. If you did not change the ID# from 1 it will still display that.

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests