Does anyone have the schmatic for the above listed cable or a resource to get the specs on how to build one. Cost for factory cable is $79.00. Most of us can build anything if we put our mind to it.
Thanks
Programming cable for Kenwood TM-271A Radio P/n PG-5D
Moderator: willbartlett
-
- Posts: 1
- Joined: Wed Aug 04, 2004 11:46 am
- Location: Columbia, South Carolina
271A programing cable
Hello
Its more then getting the wires to the correst pins
I open my cable up to see way they used a 25 pin connnector
I was going to change it over to a 9 pin one
There is one big IC inside and 2 smaller chips
If you want I can draw out the wires to pins but on the chips
not sure where you would go to find them
.
Its more then getting the wires to the correst pins
I open my cable up to see way they used a 25 pin connnector
I was going to change it over to a 9 pin one
There is one big IC inside and 2 smaller chips
If you want I can draw out the wires to pins but on the chips
not sure where you would go to find them
.
-
- Posts: 4
- Joined: Wed Jun 08, 2005 4:34 pm
Heres a link to one that should work
http://www.cqham.ru/uniprog2_eng.html
personally i use the following no problems with any radios yet
http://www.makinterface.de/index_e.php3
http://www.cqham.ru/uniprog2_eng.html
personally i use the following no problems with any radios yet
http://www.makinterface.de/index_e.php3
tm-271a
i have used these cables and have had no problem 21.95 shipped
wiz706
http://www.citlink.net/~wiz706/prod04.htm
wiz706
http://www.citlink.net/~wiz706/prod04.htm