I just obtained an 800 LPE-200 Edacs radio which I am not too familiar with. I have the software and was able to program the radio one time. I am now not able to get it into the programming mode by holding the PTT and Monitor button down when powering up. Does anyone know what would cause this or how to reset it. Thank you.
John
LPE-200 Programming Problem
-
Rex S Taber
- Posts: 1
- Joined: Mon Feb 03, 2003 2:07 pm
LPE 200 Programming
In order to put a LPE 200 into programming mode you must hold down the PTT, Monitor and Option buttons while turning the radio on......All three are located on the side of the radio.....hope this helps
-
Glen W Christen
- Posts: 46
- Joined: Mon Feb 03, 2003 12:46 pm
LPE programming
Also beware: some early (B)versions of radio code will remove power from the option connector which feed the TQ3370 rib. NO PROGRAM. You must supply power to the RIB to program.