TK-930

bbqbert1 · Post by **bbqbert1** » Tue Apr 25, 2006 10:32 am

Trying to help out my local school distric but I am in a little over my head. I am having trouble getting a Kenwood TK-930 into the programing mode. Can anyone help? Thanks Robert

Post by **Alex** » Tue Apr 25, 2006 12:03 pm

bbqbert1 wrote:Trying to help out my local school distric but I am in a little over my head. I am having trouble getting a Kenwood TK-930 into the programing mode. Can anyone help? Thanks Robert

You need a programming interface in order to program the radio -

Explain the exact methodolgy your employing to program this radio. We need more information!

-Alex

bbqbert1 · Post by **bbqbert1** » Tue Apr 25, 2006 10:42 pm

I have the KPG-5D software and a KPG-4 programing cable but I have been told the radio needs to be in the program mode. I have tried holding all the buttons on power up but I can't get the radio to go into program mode. With just the software and the cable pluged into the radio I get a comunication error that says to check cable connection.

Splat · Post by **Splat** » Wed Apr 26, 2006 9:46 am

I forget what keys need to be held down... Did you try F1, help file?

bbqbert1 · Post by **bbqbert1** » Wed Apr 26, 2006 11:07 am

Yes I did. I may not have a full version of the software. When I tried to use the help file it just says file not found. There is a 15 pin plug in the back of the radio. I was wondering if I needed to do some type of jumper there? Does this ring any bells? Thanks Robert

Birken Vogt · Post by **Birken Vogt** » Thu Apr 27, 2006 10:49 am

You need to have the radio in program mode, don't remember exactly how but it's not hard. As far as the help goes, first start the program then in one of the right hand pull down menus there is an item called "help path"...use that item to tell it what directory on the computer the help file is in...should be the same as the program most likely...then you'll get the help at least

Birken

bbqbert1 · Post by **bbqbert1** » Thu Apr 27, 2006 11:03 pm

Getting the radios into program mode has been the problem the whole time. Everyone I talk to about this says I need them in program mode but no one can tell me how to get there. I have tried all combinations of holding buttons down on power up but no luck. Whats next? Any ideas?
Thanks Robert

Splat · Post by **Splat** » Fri Apr 28, 2006 5:13 pm

Copied from elsewhere.... Hold the "A" key for 2-3 seconds while turning on the radio. On the alpha-numeric head it will say PROGRAM after releasing the "A" key. On the non-alpha head the display will have a pair of dashes [- -] . You should now be able to read and write to the radio..

N3AAG · Post by **N3AAG** » Sun Apr 30, 2006 5:42 am

You also can try ask in TK-930 / TK-930 group http://groups.yahoo.com/group/Kenwood_TK-930_931/

bbqbert1 · Post by **bbqbert1** » Sun Apr 30, 2006 7:41 pm

OK I think we go it. I thought I had an alpha-numeric display but I guess I don't. I have the 2 dashes. Now I need to get the connection problem worked out and I home free. Thanks for all the help everyone! Robert

The Radio Information Board

TK-930

TK-930

Re: TK-930

Programing the TK-930

TK-930

TK_930