Page 1 of 1
Repair Display Lamp on Kenwood TK760H
Posted: Mon Jun 21, 2004 1:15 pm
by millerchief
Could anyone give me aheads up on how to repair the display lamp on a Kenwood TK760H. I don't have a service book on this radio.
James
Posted: Tue Jun 22, 2004 2:32 am
by Uncle Zhenya
The display lamp on a Kenwood TK760H (not TK760GH) may die because of the Q405 current regulator malfunction. The Q405 (2SB1132) transistor may be dead. It may be no contact in R455 10 Ohm resistor, it is easy to find, it hangs on its long legs. I had this problem because of the bad resistor.
Posted: Wed Aug 04, 2004 10:57 pm
by Wes
We have repaired several of these on the older 60 series mobiles. There are 3 of the surface mount LED bulbs on each end of the display. On each end the LED are in series. If one of the 3 goes out the other 2 dont work. It is common that they will get a broken solder joint and a lot of the time they just need resoldering. If indeed they are burned out, then you can use an ohm meter to find the bad one and replace it. I have never see over 1 or 2 bad at a time.
Hope this helps.
Wes