Page 1 of 1
Posted: Thu Jan 24, 2002 5:46 pm
by ltec123
Hi guys,
How hard is it, if possible to change the display on a TK-380.
And while your'e at it, the part numbers.
Thanx
Posted: Wed Mar 06, 2002 11:31 am
by micor47
It is not hard at all. Take the screws that hold the chassis out there are only two. Next with a small screwdriver carefully pry out the chassis from the housing. Next remove the rubber housing that contains the speaker and dtmf pad if you have dtmf. Next remove the six screws that hold the front board to the chassis. Carefully pry up the two ribbon cables that are attached to the mainboard then you can remove the front board that contains the display. The display is attached to the front board via another ribbon cable and plastic tabs. Just remove these and there you are. Assembly is just the reverse. The part nuber for the display is :
B38-0810-05.
Rich
Posted: Mon Mar 11, 2002 7:09 pm
by ltec123
Thanks.
Do you know any better/cheaper place to buy Kenwood parts then
http://www.kenwoodparts.com.?
Thanks
PS I am not a Kenwood dealer...
Kenwood Parts
Posted: Mon Mar 11, 2002 10:14 pm
by micor47
We are a kenwood dealer and if you need parts you can call us toll free and we either may have the part in stock or can order it.
1-800-264-1175 ask for Robert or Rich
Posted: Mon Mar 11, 2002 11:06 pm
by ltec123
Hi Rich,
Thanks again, will do!
Lt