Page 1 of 1
VX900U with ANI-F board
Posted: Tue Jan 03, 2006 3:05 pm
by n3obl
Purchased one off ebay. Did not know til i took battery off and wowla.. a ANI-F board.
Can this be programmed through the Programming software, to set ID Number.
Frank N3OBL
FF/EMT
Posted: Thu Feb 09, 2006 3:17 pm
by Muggsy09
Depends on the model of the board, the software you're using and the radio. The board I have (purchased off ebay) does MODAT signalling cannot be programmed through the software, the ID number was pre-programed and then enabled in the software.
Posted: Thu Feb 09, 2006 9:12 pm
by RadioTweester
Frank
The ANI-F board is manufactured by Midian -
http://www.midians.com - and will need to be programmed outside of the radio with Midian's KL-3 Programmer and the VPI-1 interface. Here's the link to the board page
http://www.midians.com/html/specspage.a ... +Signaling
The Cimarron -
http://www.cimtechcorp.com - boards can be programmed while they're in the radio using Vertex's CE-73 software. I really like the VMDE-200 because it also decodes, but the ANI-F will does a lot more functions and as a freebie vs $130; heck, that's very COOL.
-Tom
Posted: Thu Feb 09, 2006 10:22 pm
by n3obl
Old Post. Had somebody here on board program the ANI board. Orignally came set up for 5tone.
Frank N3OBL
FF/EMT