The Radio Information Board

Hey guys I am trying to get this thing to scan but not have the big skip when it stops on a channel other than my pri channel ....the only thing I have found that works is to just take off the pri ....but I really dont want to do that. Any Ideas?

The short answer... No.

You can extend the time your priority channel is checked (under [Common] --> [Scanning] --> [Scan Parameters] it's from 1/2sec to 3sec check time).

Another idea is to leave priority off and mess with the [Scan time 1] time. Maybe down to 1/4 second. (Not really a solution I know).

I'll post another reply if I find a way to do what you're looking for but it doesn't lookvery good.

-Tom

I was thinking the same thing ....I like the pri function but it gets aggervating at times when it cuts out other traffic