Page 1 of 1
kenwood tk 830 speaker problem
Posted: Mon Mar 03, 2008 10:49 am
by med1874
I am having problems with my tk 830G I have hooked the speaker up and no volume.. when I power it on I get the load beep but no volume from the active frequncies.. any ideas..
Thanks
med1874@alltel.net
Re: kenwood tk 830 speaker problem
Posted: Mon Mar 03, 2008 8:31 pm
by ka7wnf
Do you have PL on the receive frequencies?
Re: kenwood tk 830 speaker problem
Posted: Mon Mar 03, 2008 8:59 pm
by med1874
I do on some but it does it with or with out PL also I tried the speaker at the remote head and the radio and it is the same.. I have also tried a diffrent speaker
Re: kenwood tk 830 speaker problem
Posted: Wed Mar 05, 2008 8:32 am
by n5tbu
That amp has a few inputs.....it is possible to have one section go bad and still get the power on beep. Try the amp board from another radio and see if it works,also could be a bad relay on the same board,try programming it for PA and see if that works.
mod
Re: kenwood tk 830 speaker problem
Posted: Wed Mar 05, 2008 8:36 am
by med1874
Ok thanks I will try that