tk-2170

gtfd236 · Post by **gtfd236** » Fri Oct 06, 2006 9:29 pm

Does anybody know how to make it so you can listen to radio traffic and still have 2 tone decode? I know on some kenwoods you have an option of and or. I know on the vertex you can choose on or off duty. Also does any pody know how to field progam the tk-2170??

Meatball · Post by **Meatball** » Sat Oct 07, 2006 3:31 pm

You can listen to traffic and still have two-tone decode if you set the channel for optional 2-tone signalling, but you set the signalling for the group to "OR."

In other words, it will unmute traffic on CG decode, but will also sound a beep tone when it gets a two-tone activation. The "AND" setting requires the radio to have a matching CG AND a matching two-tone and will not unmute unless you get the two-tone.

I don't know how to field program the TK-2170 though.

gtfd236 · Post by **gtfd236** » Sun Oct 08, 2006 1:45 pm

Where is that in the programming software?

Meatball · Post by **Meatball** » Sun Oct 08, 2006 11:09 pm

It's usually listed under "Optional Signalling Decode Condition." It should either be under either "Zone Edit" or "Group Edit."

I don't have the TK-2170 programming software in front of me, so I can't tell you exactly where it is in this particular program. If you poke around enough, you should be able to find it.