ignition sense wiring help TK-790

stangmansvo · Post by **stangmansvo** » Fri Aug 11, 2006 11:57 am

Hi all
Im looking for help to setup a TK-790 remote head radio to ignition sense.
thanks
steve

Meatball · Post by **Meatball** » Fri Aug 11, 2006 10:52 pm

The ignition sense lead goes into pin 1 of the head accessory connector. Fuse for 3A.

Remove R504 and move it to the blank pads for R506. This is a surface mount component and care must be taken (I use a small pair of low-wattage soldering irons).

R504 is located on the right side of the top PC board.