tk-730H programming issues and SVR-200UD
Posted: Thu Nov 09, 2006 7:22 pm
I am trying to program a tk-730H-1 Does the H model take something other than kpg7d? if so what.
Unit has a basic 32 head on it. I try to read the radio. I start out in the PG program mode on the display. I go to read the radio and the head changes to 16 and then counts down to 1. The PC shows reading blocks 1-16 and 50% then errors out. The radio head goes to ER.
It looks like it thinks the head is 16 channels. anyone seen this, anyone know a way around this? I have not been able to write any data, I keep getting a mismatch error and the radio goes into ER mode.
Help?
The radio was part of a SVR-200UD in car repeater with a dual head. I have unconverted the VHF side, FAA chips, unsoldering jumper at w106. Anyone else pull one of these apart?
Unit has a basic 32 head on it. I try to read the radio. I start out in the PG program mode on the display. I go to read the radio and the head changes to 16 and then counts down to 1. The PC shows reading blocks 1-16 and 50% then errors out. The radio head goes to ER.
It looks like it thinks the head is 16 channels. anyone seen this, anyone know a way around this? I have not been able to write any data, I keep getting a mismatch error and the radio goes into ER mode.
Help?
The radio was part of a SVR-200UD in car repeater with a dual head. I have unconverted the VHF side, FAA chips, unsoldering jumper at w106. Anyone else pull one of these apart?