Programming GE MDX

Forum dedicated to the Harris PSPC Product group items such as Orion, M7100/M7200/M7300, P7100/P7200/P7300, Harris Unity XG-100, GE Orion, GE Master Repeaters, EDACS Trunking, Pro Voice, PC Configure, RPM, and other topics relating to Harris, MA-Comm, Ericsson, GE products.
Post Reply
Maddog949
Posts: 7
Joined: Fri Dec 27, 2002 6:00 pm
Location: New York

Programming GE MDX

Post by Maddog949 »

I would like to program a conv. GE-MDX radio. I have the Rib/Cables/Computer I need, but am lacking the software. I have looked on Radtek.com but cannot find / or don't know what software to use. Also, when programming the radio, are there any keypad combinations needed to put the radio into it's programming mode. Thanks for any help. MJT

:beer:
Top
Prospect62

Post by Prospect62 »

You'll need EDACS4 software or ProGrammer as it's also called. Not sure where you'll find it, it isn't on radtek. To get the MDX into programming mode, hold the volume button in the up position while turning the radio on. Also, do not connect the RIB to the radio until the software prompts you to, otherwise the software will keep giving you error messages. Good luck. :beer:
Top
Post Reply

Return to “Harris Public Safety Communications (PSPC) Equipment”